Toyota (Oval): Morimoto XB LED


$0.00

10 or more

$0.00

Wholesale

$0.00

MSRP

+
Add to Cart

Product Details

No Substitutes: If you don't have LED powered fog lights, then you're just behind the times! Thankfully the new Morimoto XB LED projector fog lights: Look great. Are well-built. Perform like champs. Have a virtually infinite life span. An unbeatable warranty, And best of all you won't need to sell your soul to afford them! Many of the guys here at the shop use them on their own vehicles, and they're easily one of our most popular product lines.

Compatible: With many modern applications from Toyota, these complete fog light housings will swap in place of the original halogen units that they're designed to replace, using all of the stock mounting locations. Their aim can be perfectly dialed in with the integrated height adjusters. Check the compatibility section below for a list of known applications.

Note about Fitment: For most Toyota / Lexus installs, these are a 100% direct fit in place of the stock fog lights. For certain fitments such as the 2014-2018 Toyota 4Runner, the mounting points are very close but not 100% identical to stock, so some minor trimming or adjustment of the plastic bracket on the Morimoto XB fog lights may be required.

Plug n Play: Wiring is easy too! The Toyota LED fog lights are designed to work without any special wiring. They will plug into the factory connectors for the stock fog lights and each assembly includes all necessary connectors, rubber seals, and pigtails for a plug n play install.

Powered: By three Philips Luxeon-T 5500K LED's that produce around 1200 raw lumens per side. The projector based optics concentrate a total of 2400 lumens of pure white light into a beam that's super wide and perfectly distributed for use as a fog light. Make no mistake, these will produce a much different [better] result than slapping some LED replacement bulbs into your stock housings. The XB fogs meet & exceed all SAE, DOT, and ECE regulations.

Well-Built: Their durable polycarbonate lens will resist the test of time, keeping the housings looking new for many years to come. The powder-coated cast aluminum housing is light-weight and much stronger than comparable plastic alternatives. Doubling as the heat-sink for the LED's, the housings completely protect the internals from moisture and road debris. We've sold many thousands of these Toyota fog lights and to date, have only seen one or two develop a problem...no joke!

Word on the Street: Don't just take our word for it, check out these Install & Review videos that previous customers have put together! Everybody loves a good YouTube demo, so check it out HERE!, HERE!, HERE!, and HERE!

Overview Video: Prefer videos? Check out this helpful video the lineup of XB LED fogs!

Trusted: For more than a decade, we've worked hard to earn our killer reputation. Car guys world-wide know that TRS carries the internet's best selection of high performance automotive and powersport lighting products at the best prices, and we've got the best, most knowledgeable team of real enthusiasts to help back it up. If we sell it, then you bet we've put it to the test on our own cars, trucks, and bikes. Need a recommendation on parts for your project? Got a tech question? Wholesale inquiry? Contact Us

Product Specs

  • What's Included

  • FOG LIGHTS: 2x Type T Morimoto XB LED

  • WIRING: Plug-n-Play Connection Kit

  • OPTIONAL: Lamin-X Yellow Film Kit

  • WARRANTY: 10 Years

  • SWAG: Morimoto Decal

  • Compatibility

  • REPLACES TOYOTA PART #: 81220-06071, 81210-08020

  • 4RUNNER: 2010-2017

  • AVALON: 2007-2015

  • CAMRY: 2007-2014

  • COROLLA: 2009-2016

  • HIGHLANDER: 2008-2010

  • MATRIX: 2009-2013

  • PRIUS: 2010-2016

  • PRIUS C: 2012-2016

  • PRIUS V: 2012-2016

  • RAV4: 2006-2012

  • SIENNA: 2010-2016

  • SOLARA: 2006-2008

  • TACOMA: 2012-2017

  • TUNDRA: 2014-2017

  • VENZA: 2009-2014

  • YARIS: 2007-2016

  • SUBARU LEGACY: 2015-2017

  • CERTIFICATIONS: DOT, ECE, SAE

  • Tech Specs

  • INPUT SOCKET: Sealed H11 Male

  • WEATHER RATING: IP67 Waterproof

  • LENS MATERIAL: High Impact Polycarb (UV-Resistant)

  • SHELL / HEAT SINK: Powder Coated Cast Aluminum

  • LIGHT SOURCE: 3x Philips Luxeon-T (White) / Osram (Amber)

  • LED OPTICS: Kuria Fog-Projection Lens

  • INTENSITY: 1,200lm (raw; each)

  • COLOR: 5500K (Pure White) or 2800K (Amber)

In Action

Product Reviews

4 out of 5 stars

Not a Perfect Fit

Michael Jones Reviewed: 07.17.2019

These did not fit my 2016 Tundra perfect. The plastic taps on the new fogs lights are spaced too far apart, but still manage to go in. This causing a slightly larger gap than the original fog lights. It's not noticeable nor effects the light that I can tell. I still would of liked a perfect fit for the price though.


5 out of 5 stars

Great factory replacement on 2019 Tundra

Justin Glasscock Reviewed: 03.20.2019

Installed these on my 2019 Tundra SR5 and love them, much higher output than the factory fog lights. The projection pattern is a bit different, more wide and short than just throwing the light everywhere like the factory fog lights. You will need to angle them up some in the Tundra, the angle it comes at is too low and is barely visible above the hood.

NOTE: I cut out the bottom of the bottom tab holder on the fog light bracket, the mounting tabs on these are slightly further apart than the factory. The top bracket I didn't modify. There will be roughly 1/8 inch gap between the outside of the fog light holder and the new lens once you install them.


3 out of 5 stars

Not a clean fit

Adam . Reviewed: 01.28.2019

Installed on my 2015 4Runner. Slight modification had to be done on the tabs and the lens does not sit flush with the vehicle body, about a 1/4"-1/2" gap.


5 out of 5 stars

2016 Rav4 SE

Luis Gamarra Mendoza Reviewed: 01.03.2019

I was skeptical to buy these for my 2016 Rav4 SE since the vehicle was not on the compatible list. I am happy to report that these fit. The original housing was held with two screws. The Morimoto XB LED fit but I could only use one screw to tighten them down. Even with one screw the housing is held on secure. These match perfectly with the stock LED headlights.


5 out of 5 stars

Awesome Fogs!

DUSTIN CURRENT Reviewed: 12.19.2018

These foglamps are extremely well built and have excellent performance. Best part, they take 15 minutes to install if you know what you're doing!


5 out of 5 stars

Beautiful lights

John Rainier Reviewed: 12.10.2018

Ridiculously better than stock and the color is beautiful.

Install was about 30 minutes, but if you have small hands it will be 10. I couldn't go under my Tacoma to install them, so I had to go through the engine. If you have large hands, it's a pretty tight squeeze. If you have medium to small hands, you won't struggle at all.

Would definitely recommend!


5 out of 5 stars

Great purchase, Excellent product!

Jou Moua Reviewed: 10.11.2018

So I have owned these for about 3 years. Decided to finally write a review. They are on my 2010 Camry. I bought these to replace a broken one, that the dealer wanted about the same price for one fog light, that I paid for the pair here. I was going to go with an Amazon brand, because I wanted something cheap. I'm glad I didn't go that route. I have to say, this is the best purchase I have made.

I have had headlight bulbs go out and I didn't notice it because the fog lights were bright enough to light the road. Quality was great, price is well worth it. I think the only gripe I have is that I didn't buy it sooner. again one of the best purchases I made. I would buy TRS product again and definitely recommend to anyone who is looking for replacements.


4 out of 5 stars

2018 4runner. Modifications needed to install.

Kyle Elkins Reviewed: 06.10.2018

As stated above, these do not fit 2018 4runners that well. Honestly, would have gone with RIGIDs option had I known this much outside work needed to be done. I needed to file down two mounting tabs and essentially force the bracket into place since the screw spread is slightly wider. The correct part was sent, but the mount is wider than my stock set up. A coworker has a 2014 and she had no issues at all. Guess they changed the fog light mount slightly.

Now for the good. The light pattern is very nice, and the blackout look is very attractive. Matches 4500k HIDs pretty well.


5 out of 5 stars

Awesome Fogs!

James Morel Jr Reviewed: 05.01.2018

I have a set of these for my 2016 4runner, I would never go back to stock these are true fog lights with a nice low beam pattern as opposed to the factory lights which have a pattern more like driving lights. I only wish they came in amber because i don't really care for the lamin-x. Lets see these with yellow leds!!!


5 out of 5 stars

Aesthetically Pleasing.

Michael-Glenn Osalbo Reviewed: 04.19.2018

Looks way better than stock. It IS bright when and I know it will lost long. It was an easy install on my 15' Legacy. I applied the yellow ppf film for protection. The heat gun helped with forming and applying the film. I will say the light out put is better tahn stock one bulb. However, when i had upgraded to LED bulb intomy stock fog housing, it was brighter than the xb led fog light. No matter, Moriomoto produces winning products. I am definitely a satsified customer . appreciate y'all TRS!


Also Purchased