Dead Ballast: If you've got a ballast out on your Nissan, Infiniti, Acura, or Honda; buying a new OEM replacement certainly is not cheap!
Custom Setup: If you're doing a quad retrofit on a vehicle with factory HID headlights, these will allow you to run a splitter and relay harness off the factory ballast wiring without any splicing.
No Matter What: We're asking ourselves why we didn't make these sooner! These convenient adapters allow the use of aftermarket parts in place of expensive Original-Equipment ballasts with zero cutting, splicing, or re-wiring involved.
Quality: Made with stranded copper wire, fully sealed male and female connections, and protected with tech-flex mesh in between; these adapters should last longer than your original ballasts did!
Compatibility: Available to fit the OE-side connector on most modern Nissan, Infiniti's, Acura's, and Hondas that use Panasonic/Matsushita Gen III or IV ballasts, or Mitsubishi Electric Gen II or III Ballasts.
Trusted: For more than a decade, we've worked hard to earn our killer reputation. Car guys world-wide know that TRS carries the internet's best selection of high performance automotive and powersport lighting products at the best prices, and we've got the best, most knowledgeable team of real enthusiasts to help back it up. If we sell it, then you bet we've put it to the test on our own cars, trucks, and bikes. Need a recommendation on parts for your project? Got a tech question? Wholesale inquiry? Contact Us
ADAPTERS: 2x OE Ballast > 9006 Female
WARRANTY: 5 Years
ACURA: OE HID with Mitsubishi Ballasts
HONDA: OE HID with Mitsubishi Ballasts
NISSAN: OE HID with "Matsushita/Panasonic Ballasts
INFINITI: OE HID with "Matsushita/Panasonic Ballasts
OTHERS: With Matsushita/Panasonic/Mitsubishi Ballasts
OUTPUT: 9006 Female
WIRE THICKNESS: 14AWG
LENGTH: Approx 5 inches
INSULATION: TechFlex Black
Could not find this quality anywhere else. Fast and easy upgrade!
Could not find them any where else. Super easy to install, Great quality, and fast shipping!