ACME: Picked up the call from consumers who want a product that meets their expectations but aren't ready to break the bank. Their entry-level gear is the new industry standard that delivers real performance at the right price.
Don't be fooled: Not all RGB strips are built the same. Unlike competing brands that have resistors and other voltage-regulating devices soldered to the strip itself, the ACME uses an external voltage regulator. This keeps the LED's running at their prime while improving reliability. If the driver fails, it can be replaced without taking apart your headlight. If a resistor on another brands' strip fails, you're out of luck.
Construction: 3528 SMD LED chips are soldered to a flexible but stable circuit board, making them easy to install across the geometry in almost any automotive headlight.
Wiring Ready: With over 3 feet of input wiring and their inline voltage regulators, the ACME Super Flex strips are very easy to setup with any 4-pin RGB Controller such as the optional ACME M7.
Sizing: ACME does not recommend cutting the strips because the remaining LEDs would then be over-powered by the power driver. Luckily, they are offered in two lengths to fit most every purpose (3" or 16")
Trusted: For more than a decade, we've worked hard to earn our reputation. Car guys world-wide know that TRS carries the internet's best selection of high performance automotive lighting products at the best prices, and we've got the best, most knowledgeable team of real enthusiasts to help back it up. If we sell it, then you bet we've put it to the test on our own cars. Need a recommendation on parts for your project? Got a tech question? Wholesale inquiry? Contact Us
LED STRIPS: 2x ACME Super Flex (RGB)
LED DRIVERS: 2x ACME Inline Regulators
WARRANTY: 6 Months
NOTE: Will need Controller
RETROFITS: Any straight surfaces within size range
FACTORY HEADLIGHTS: Any straight surfaces within size range
OTHER USES: Not to be used external of a sealed housing
NOTE: Does not flex laterally
Length: Should not be modified/cut
INPUT: Must use 4-pin RGB Controller